The SparkSwitch is a reliable high-performance ignition switch. The switch if operated from your transmitter, I prefer their “safety” setting where you need to alter the state of a switch or channel back AND forth in order to change the state of the ignition.
Keeps you from accidentiallyswitching the ignition on or off. You always need to confirm your intent this way. All you have to do is set up your radio control transmitter for use with the switch.
Powerbox SparkSwitch: US$ 63.95
Input voltage 4.0 - 9.0 V
Regulated output voltage 5.9 V
Max. output current 2 A, peak 4.5 A
Current drain at switch side, power-on: 19 mA
MPI Voltage Regulator
The MPI voltage regulator should be used for an ignition set at 5.9V such as the round “top hat style” Moki ignition sets.
A Switch should be between battery and regulator.
Universal Connector • Input Range: 4.8V - 8.4V • Selectable Output: 5.95V or 5.4V Current: 5A continuous, 10A peak @ 7.4V input and 5.95V output, Weight: 0.7oz
MPI 5A Voltage Regulator: US$ 19.95
A123™ External Balance Duralite EXB 2500 MAH 6.6 Volt
2 cell - 6.6 volt
Max Discharge Continuous - 30c
Flight weight: 6 oz
Size: 1" x 2" x 2.6" (T/W/L)
Batteries for ignition or receiver come with Standard 22 ga Wiring &JR connectors and include charging lead and external balance lead.
6252EXB: US$ 54.95
MPI Charge Switch with LED Voltage Display:
This is a special made MPI Charge Switch which is meant for our 6.6V A123 cell packs or 7.4 Li-Ion, the switch can be set.
The three LEDs - green, yellow, & red - monitor the status of Rx pack under actual load.
MPI Charge Switch with LED Voltage Display: US$ 25
Li-Ion™ External Balance Duralite EXB 2900 MAH 7.4 Volt
Flight weight: 3.9oz (110 grams)
Size: 2.75 x 1.5 x .75in (7 x 3.8 x 2cm)
Discharge Amperage: 5.2Amp (2C)
Charge Rate: 3 Amp (1c)
High Current power output lead 12" 14ga wire & female Dean's connector. Includes charging lead and external balancing lead.
7292EXB-HC: US$ 42.95